| (Code: M918D30) |
A small but powerful Motor suitable for use with Meccano.
* Motor with 30:1 reduction gearbox
* Fitted with flange (3x3 holes approx) to attach to Meccano using the included bolts & nuts
* 147rpm on 1.5v, 293rpm on 3v |
|
| (Code: ME12R) | This motor is maximised for powerSimilar to Meccano E15R & E20R motors but runs slower with much more power. A modern powerful 12v dc motor is "sandwiched" between two sideplates. With on-off/revesing switch which can be remotely operated with an adaptor (supplied). The drive from the motor is transmitted through 90 deg via a worm and pinion giving a 25:1 reduction ratio. In this configuration the final drive is reduced but very powerful. This final drive output is then at right angles out of both side plates. This shaft can be substituted with a longer one. Side plates 127mm x 63mm (10x5 holes), width 43mm. |
|
| (Code: MEP-S) | * A motor is maximised for power with an integral gearbox
* A fixed output of 37rpm at 12v dc
* Output shaft size 4mm
* Motor & gearbox length 60mm
* Shaft length 8mm
* Fitted with a 3 x 3 hole size plate for attaching to a Meccano Model
|
|
| (Code: MBATT1) | Separate outputs each controlled by a reversing switch for 12v and 4.5v. Designed for use where current consumption is low. |
|
| (Code: E20R-Motor) | An original Meccano E20R motor
Tested and lubricated
Complete and good condition
|
|
| (Code: MBATT2) | A battery Box originally included in the 1970's Crane Multikit set and some of the last issued Liverpool Meccano sets.
There are holes to accept M611 or M612 plugs
The Motor which was included in the same sets is available separately. |
|
|
|
|
|
|
